| |
| News |
| Failure analysis |
| Many times solenoid valves fail due to an inadequate selection for certain applications. In other cases the failures are caused by a defective installation, not having followed the manufacturer’s recommendations. In many other cases, because of lack of maintenance, which should be adequate for the kind of job or the efforts the valve is subjected to. Most of the failures that occur when starting a new installation are the result of lack of cleanness in the pipelines between the filter and the valve, due to left-owers of packaging, teflon, welding residue, dirt, etc.. However, in spite of having made a good choice, a good installation and the adequate maintenance, some contingent factors may occur after the installation and disturb a suitable peration. Pumason offers its complete sales service by phone or fax to assist the end user in studying and finding a solution to the failure The following page shows the most common failures with their possible causes and solution. |
|
|
|
